HACKER SAFE certified sites prevent over 99.9% of hacker crime.
VeriSign Secured
Proceed to Checkout

No Jump Harness

No Jump Harness

Made by
 
No Jump Harness
Larger View

Our Price $9.99

Close [x]

No Jump Harness
Tell a Friend
Close [x]
You can send this product by email to a friend!
Enter the required information in the spaces provided below. They will receive an Email with the picture of this product and a link back to our site.

Your Name:

Your Email:
Friends Name:
Friends Email:
137-0110
No Jump Harness
Price: $9.99

General

They will train themselves; your dog will work against the restrain and will soon learn to stay down.

  • Over 5ft of adjustable nylon, one size fits all.
  • Sewn with heavy duty box stitching at all points of the restraint for added strength.
  • Three safety catches and four clips – all rustproof – allow you to make a comfortable, secure adjustment.
  • Color and numbered buckles for easy fitting.

 

Directions

1. Lay the no jump harness out on the floor or table and familiarize yourself with all of the parts.  Do no unbuckle or remove any straps until asked to do so in these instructions.  Locate the neck area at the black buckle, the back area at the red buckle, and the groin area at the blue buckle.  Take note that the two hind leg straps are located just behind the blue buckle.

2. Begin by unbuckling the black buckle and fitting it around your dog’s neck with the buckle area on the back of the neck.  If needed, adjust the strap to fit by pulling the strap through the buckle.  Snap the buckle together.

3. The red buckle should now be at the nape of your dog’s neck.  Be sure that the strap attached to the red buckle is running down the back of your pet toward its hind quarters.  Adjustment of the strap may be necessary.

4. Pull the remaining harness down the belly of your dog between the front legs.  Unbuckle the blue buckle and run the fork or make end around your dog’s waist and through the loop at the end of strap attached to the red buckle.  Wrap the snap or female end of the blue buckle around the other side of the dog and snap the buckle.  Adjust the straps to fit snugly.

5. The harness should be secure around the dog’s neck and groin area.  Take the two remaining straps and make loops out of each of the m by running the straps through the clips.  Wrap these around the dog’s back legs.  Adjust them so they fit securely around the legs.  Make sure the straps are threaded through the clip so they do no slide.

6. You may cut any excess strap off but remember to leave some for future adjustments.  Heat the cut ends with a match to seal them.

Reviews

in